LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2004 >> Excursion 6.8 S, 4WD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Sun Roof/T-Top/Convertible Top >> Sunroof -- Excursion & F250-F550 Super Duty >> Removal And Installation >> Roof Opening Panel Weatherstrip >> Removal

Roof Opening Panel Weatherstrip: Removal

NOTE: The roof opening panel must be initialized when repairs are carried out on any part of the roof opening panel, including: whenever the roof opening panel has been removed from the roof opening panel assembly, a new roof opening panel motor/module has been installed, or when a new roof opening panel assembly has been installed. Refer to ROOF OPENING PANEL MOTOR INITIALIZATION .
  1. Remove the roof opening panel. Refer to ROOF OPENING PANEL .
  2. Place roof opening panel, topside up, on a worktable. Take care to support the glass assembly from below to prevent damaging the mounting tabs.
  3. Remove the old roof opening panel weatherstrip by pulling up on the weatherstrip.
    Fig 1: Removing Old Roof Opening Panel Weatherstrip
    G02774566Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals