Removal and Installation

Depower the supplemental restraint system (SRS). Refer to AIR BAG RESTRAINT SYSTEMS .

CAUTION: Use care when removing the instrument panel steering column cover or damage to the cover locating tab may occur.

Remove the instrument panel steering column cover.
1. Unlock the retainers.
2. Remove the instrument panel steering column cover.
  
  Fig 1: Removing Instrument Panel Steering Column Cover
  Courtesy of FORD MOTOR CO.
If equipped, remove the tilt wheel handle.

Fig 2: Removing Tilt Wheel Handle
Courtesy of FORD MOTOR CO.
Remove the lower steering column shroud.
1. Remove the screws.
2. Remove the lower steering column shroud.
  
  Fig 3: Removing Lower Steering Column Shroud
  Courtesy of FORD MOTOR CO.
Disconnect the ignition switch electrical connector.
1. Remove the electrical connector bolt.
2. Disconnect the electrical connector.
  
  Fig 4: Disconnecting Ignition Switch Electrical Connector
  Courtesy of FORD MOTOR CO.
Remove the ignition switch.
1. Remove the screws.
2. Remove the ignition switch.
  
  Fig 5: Identifying Loosening Torque Of Ignition Switch Screws
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.