Brake Vacuum Pump

Fig 1: Removing Brake Vacuum Pump With Torque Specification

Courtesy of FORD MOTOR CO.

Remove the accessory drive belt. For additional information, refer to ACCESSORY DRIVE .
Release the clamp and disconnect the vacuum hose.

Fig 2: Disconnecting Vacuum Hose
Courtesy of FORD MOTOR CO.

NOTE: The bolt behind the pulley is accessed through the pulley with an extension and a short socket.

Remove the 3 bolts and the vacuum pump.
- To install, tighten to 47 Nm (35 lb-ft).
  
  Fig 3: Removing Bolts Of Vacuum Pump
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.