Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Depower the supplemental restraint system (SRS). For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .
Insert the ignition key into the lock cylinder and turn the ignition switch to the RUN position.
- Push the ignition switch lock cylinder release tab with a punch while pulling out the ignition switch lock cylinder.
  
  Fig 1: Pulling Out Ignition Switch Lock Cylinder
  Courtesy of FORD MOTOR CO.
If equipped, twist the tilt wheel handle and remove it.
Remove the 3 screws and the upper and lower steering column shrouds.
Remove the key release button.
1. Remove the bolt.
2. Remove the spring.
3. Remove the key release button.
  
  Fig 2: Identifying Key Release Button, Spring And Bolt
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
Repower the supplemental restraint system (SRS). For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .