LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Mustang Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1635 (Engine - 6.0L Diesel -- F250-F550 Super Duty 6.0L (99P F450/550)) >> In-Vehicle Servicing >> Oil Pump >> Removal

Oil Pump: Removal

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the crankshaft front seal. For additional information, refer to Crankshaft Front Seal .
    2. Fig 1: Locating Oil Pump Body Bolts
    G03887280Courtesy of FORD MOTOR CO.
  2. Remove the bolts, the gerotor cover and discard the O-ring seal.
    3. Fig 2: Identifying Inner And Outer Oil Pump Drive Rotors With Alignment Marks
    G03887281Courtesy of FORD MOTOR CO.
    NOTE: Mark the front of the inner and outer gerotor for correct reassembly.
  3. Remove the inner and outer gerotors.
  4. Inspect the oil pump components and install new components as necessary.
    • Inspect the oil pump for excessive metal particles.
    • Inspect the oil pump for gouging, cracks or deep scratches.
    • Inspect the oil pump inner and outer gear rotors for damage or excessive wear.
scientia non olet · About LEMON Manuals