All vehicles

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Right Exhaust Manifold Torque Sequence

Courtesy of FORD MOTOR CO.

NOTE: Start installing the bolts with the second bolt from the rear on the top. The hole diameter is smaller, therefore allowing alignment of the remaining bolts.

NOTE: When installing the exhaust manifolds, only use prevailing torque hex flange bolts with an interference fit.

NOTE: Apply anti-seize lubricant to the bolt threads prior to installing the bolts.

Install the RH exhaust manifold and tighten the 8 bolts in the sequence shown.
- Tighten to 38 Nm (28 lb-ft).

NOTE: Apply anti-seize lubricant to the bolt threads prior to installing the bolts.

Install the 2 RH exhaust manifold-to-turbocharger adapter pipe nuts.
- Tighten to 27 Nm (20 lb-ft).
Install the RH fender splash shield. For additional information, refer to FRONT END BODY PANELS article.

Connect the LH and RH battery ground cables. For additional information, refer to BATTERY, MOUNTING AND CABLES article.