LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Mustang Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1635 (Engine - 6.0L Diesel -- F250-F550 Super Duty 6.0L (99P F450/550)) >> In-Vehicle Servicing >> Crankshaft Front Seal >> Removal

Crankshaft Front Seal: Removal

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the crankshaft pulley. For additional information, refer to Crankshaft Pulley .
    2. Fig 1: Identifying Crankshaft Seal
    G03887244Courtesy of FORD MOTOR CO.
  2. Punch 2 holes in the seal.
    3. Fig 2: Removing Crankshaft Front Seal
    GF0005709Courtesy of FORD MOTOR CO.
  3. Using the special tool, remove and discard the crankshaft seal.
    4. Fig 3: Removing Crankshaft Pulley Wear Sleeve
    GF0005710Courtesy of FORD MOTOR CO.
    NOTE: Production engines will not have a wear sleeve.
  4. If equipped, remove and discard the crankshaft seal wear sleeve.
scientia non olet · About LEMON Manuals