LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Mustang Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1635 (Engine - 6.0L Diesel -- F250-F550 Super Duty 6.0L (99P F450/550)) >> In-Vehicle Servicing >> Crankshaft Front Seal >> Installation

Crankshaft Front Seal: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Thoroughly clean the crankshaft front seal mounting surface.
  2. Apply Threadlock 262 to the outer circumference of the leading edge of the crankshaft.
    3. Fig 1: Installing Oil Seal And Wear Sleeve Assembly
    GF0005711Courtesy of FORD MOTOR CO.
    NOTE: New seal and wear sleeve must not be separated.
  3. Using the special tool, install a new oil seal and wear sleeve assembly.
  4. Install the crankshaft pulley. For additional information, refer to Crankshaft Pulley .
scientia non olet · About LEMON Manuals