Removal And Installation
WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. They must be replaced with the same part number or an equivalent part if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.
- Remove the stabilizer bar link lower nut and bushing.
- Discard the nut.
- To install, tighten to 80 Nm (59 lb-ft).
- Remove and discard the stabilizer bar link upper nut, bolt and washer.
- To install, tighten to 150 Nm (111 lb-ft).
- Remove the stabilizer bar link.
- To install, reverse the removal procedure.