Removal and Installation

Place the gearshift lever in first gear.
Disconnect the brake pedal motor electrical connector.

Fig 1: Disconnecting Brake Pedal Motor Electrical Connector
Courtesy of FORD MOTOR CO.
Disconnect the brake pedal motor-to-accelerator pedal cable from the accelerator pedal by pulling the cable retainer outward.

Fig 2: Disconnecting Brake Pedal Motor-To-Accelerator Pedal Cable From Accelerator Pedal
Courtesy of FORD MOTOR CO.
Disconnect the brake pedal motor-to-brake pedal cable from the brake pedal by pulling the cable retainer outward.

Fig 3: Disconnecting Brake Pedal Motor-To-Brake Pedal Cable From Brake Pedal
Courtesy of FORD MOTOR CO.
Disconnect the transmission shift cable from the steering column shift tube lever.

Fig 4: Disconnecting Transmission Shift Cable From Steering Column Shift Tube Lever
Courtesy of FORD MOTOR CO.
Remove the spotlight switch retaining pin.

Fig 5: Removing Spotlight Switch Retaining Pin
Courtesy of FORD MOTOR CO.
Slide the stoplight switch (13480) and booster push rod from the brake pedal pin.

Fig 6: Sliding Stoplight Switch And Booster Push Rod From Brake Pedal Pin
Courtesy of FORD MOTOR CO.
Remove the brake pedal motor bolts.

Fig 7: Removing Brake Pedal Motor Bolts
Courtesy of FORD MOTOR CO.

NOTE: Brake pedal motor-to-pedal cable must be routed around the main wiring (14401) harness to prevent cable binding.

NOTE: Hand-tighten the bolts.