LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Excursion 7.3 F, RWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake System Actuation - Excursion & F250-F550 Super Duty >> Removal And Installation >> Brake Fluid Reservoir >> Installation

Brake Fluid Reservoir: Installation

    NOTE: Whenever replacing the brake master cylinder reservoir, replace the grommets.
  1. Install the brake master cylinder reservoir.
    1. Lubricate the two grommets with High Performance DOT 3 Motor Vehicle Brake Fluid C6AZ-19542-AB or equivalent fluid meeting Ford specification ESA-M6C25-A, and insert the grommets into the brake master cylinder.
    2. Press the brake master cylinder reservoir into the grommets until it is fully seated.
    3. Connect the brake master cylinder fluid level switch.
    4. Fill the brake master cylinder reservoir with clean High Performance DOT 3 Motor Vehicle Brake Fluid C6AZ-19542-AB or equivalent fluid meeting Ford specification ESA-M6C25-A.
      Fig 1: Installing Brake Master Cylinder Reservoir
      G01543451Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals