LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Excursion 7.3 F, RWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel And Console -- Excursion & F250-F550 Super Duty >> Removal And Installation >> Instrument Panel - Center Finish Panel >> Removal and Installation

Removal and Installation

  1. Remove the instrument panel cluster finish panel. Refer to INSTRUMENT PANEL - Cluster Finish Panel .
  2. Remove the screws and the utility hook.
    • If equipped with the dual fuel switch bezel, disconnect the electrical connector.
      Fig 1: Removing Screws And Utility Hook
      G01556001Courtesy of FORD MOTOR CO.
  3. Remove the lower ashtray/beverage holder screws.
    NOTE: Open the ashtray/beverage holder to gain access to the lower beverage holder screws.
    Fig 2: Removing Lower Ashtray/Beverage Holder Screws
    G01556002Courtesy of FORD MOTOR CO.
  4. Remove the ashtray/beverage holder.
    1. Remove the upper screws.
    2. Remove the ashtray/beverage holder.
      Fig 3: Removing Ashtray/Beverage Holder
      G01556003Courtesy of FORD MOTOR CO.
  5. Remove the instrument panel center finish panel.
    1. Remove the screws.
    2. Remove the instrument panel center finish panel.
    • Disconnect the electrical connector.
      Fig 4: Disconnecting Electrical Connector
      G01556004Courtesy of FORD MOTOR CO.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals