Removal and Installation

Vehicles equipped with adjustable pedal 

1. Remove the brake pedal motor. Refer to Brake Pedal Motor  .
2. Remove the stoplight switch retaining pin.
   Fig 1: Removing Stoplight Switch Retaining Pin

   Courtesy of FORD MOTOR CO.
3. Slide the stoplight switch (13480) and booster push rod from the brake pedal pin.
   Fig 2: Sliding Stoplight Switch And Booster Push Rod From Brake Pedal Pin

   Courtesy of FORD MOTOR CO.

   All vehicles 

4. Remove the brake pedal and bracket retaining nuts.
   Fig 3: Removing Brake Pedal And Bracket Retaining Nuts

   Courtesy of FORD MOTOR CO.

   Vehicles equipped with 7.3L diesel engine 

5. Remove the air cleaner assembly.

   All vehicles 

6. Position the brake booster assembly out of the way.
7. Remove the brake pedal and bracket.
CAUTION: The brake pedal (2455) and the accelerator pedal (9725) must be in the same position before installation. The pedals must be in the completely rearward (toward the driver) position.
8. To install, reverse the removal procedure.