Performing Self-Test

WARNING: This page is about a different variant/trim than selected.

To perform self-test, turn ignition off. Ensure test equipment is properly attached and all accessories are off. If vehicle is equipped with an auxiliary powertrain control system (RPM control), it must be turned off before performing self-test. Using NGS tester, perform the following steps:

Select VEHICLE & ENGINE SELECTION menu.
Select VEHICLE, YEAR & MODEL.
Select DIAGNOSTIC DATA LINK.
Select PCM - POWERTRAIN CONTROL MODULE.
Select DIAGNOSTIC TEST MODE.
Select KOEO OUTPUT STATE SELF-TEST.
Turn ignition on.
Follow operating instructions from NGS tester menu.
Press and release accelerator pedal to cycle output state high on relays, solenoids, WAIT TO START light, CID, IDM EF, FDCS, and TCIL. When accelerator pedal is pressed for first time, glow plug relay will receive a 5 second on-command.
After test has been completed, cycle ignition off before performing other self-tests or driving vehicle.