Diagnostic Aids
WARNING: This page is about a different variant/trim than selected.
NOTE:
After each service or repair procedure has been completed, reconnect all components. Clear DTCs and repeat QUICK TEST procedures to ensure all electronic engine control systems are working properly and DTCs are no longer present.
WARNING:
Injector Driver Module (IDM) supplies 115 DC volts to all fuel injectors. DO NOT pierce injector wiring harness, severe electrical shock may occur.
Perform this test when directed by QUICK TEST. This test is only intended to diagnose the following components and circuits:
- Injector Driver Module (IDM) Relay
- Powertrain Control Module (PCM)
- Wiring Harness Circuit (IDM-EN)