Accessing OSR Test Mode (New Generation Star Tester)

WARNING: This page is about a different variant/trim than selected.

To enter OSR test mode, turn ignition switch to OFF position. Ensure test equipment is properly attached. Using NGS tester, perform the following steps:

Select VEHICLE & ENGINE SELECTION menu.
Select NEW VEHICLE, YEAR & MODEL.
Follow operating instructions from scan tool menu.
Select GENERIC OBD-II FUNCTIONS. Press TEST button if monitors are not complete.

NOTE: If all monitors are incomplete, OSR test will automatically be displayed along with a message.

Press TEST button to display OSR test.
Select ON-BOARD SYSTEM READINESS.