Power Steering Pump Pulley - CIII Pump

Power Steering Pump Pulley - CIII Pump

Special Tool(s):

Special Tool(s)

Removal and Installation

Vehicles with 6.0L engine
1. Remove the engine cooling fan.

All vehicles





2. Rotate the belt tensioner and remove the engine drive belt from the power steering pump pulley.

Vehicles with 5.4L and 6.8L engine
3. With the vehicle in NEUTRAL, position on a hoist.

All vehicles





4. Using the special tool, remove the pulley.
- Inspect the pulley or marks in the web area near the hub. If there are two paint marks, discard the pulley. If there is no paint or one paint mark, use a paint pencil to mark the web area of the pulley near the hub.
5. To install, reverse the removal procedure.





6. CAUTION: Replacement of the power steering pump pulley is necessary after being removed and installed two times.

Using the special tool, install the power steering pump pulley.