Power Steering Pump - CIII
Power Steering Pump - CIIISpecial Tools:
Special Tool(s)
Removal and Installation
All vehicles
1. Remove the power steering pump pulley.
Vehicles with 6.0L engine
2. Remove the bolt and position the cable aside.
All vehicles
3. Disconnect the pressure line and return hose.
Vehicles with 5.4L and 6.8L engines
4. Remove the bolts and the pump.
Vehicles with 6.0L engine
5. Remove the bolts and the pump.
All vehicles
6. To install, reverse the removal procedure.
7. Using the special tool, install a new teflon seal on the pressure line fitting.
8. Fill, purge and leak check the system.