Valve Cover RH

Valve Cover RH

Removal and Installation

All vehicles
1. Remove the evaporator case.





2. Loosen the clamp at the charge air cooler.





3. Loosen the clamp at the turbocharger and remove the charge air tube.





4. Disconnect the wiring retainer from the stud.





5. Disconnect the glow plug controller electrical connectors and the wiring retainer.





6. Remove the nuts and the glow plug controller.

Vehicle with automatic transmission





7. Remove the nut and position the transmission fluid indicator and tube assembly aside.

All vehicles





8. NOTE: Mark the position of the valve cover bolts for valve cover bolt installation.

Remove the eleven bolts and the valve cover. Clean and inspect the valve cover gasket and install a new gasket, if necessary.
9. To install, reverse the removal procedure.