Removal and Installation
Brake Master CylinderRemoval and Installation
All vehicles
1. Disconnect the battery ground cable.
2. Remove the air cleaner housing.
3. Disconnect the fluid level sensor connector.
4. Disconnect the brake pressure switch connector, if so equipped.
5. Disconnect the brake tubes.
Vehicles with Hydro-Boost
6. Remove the power steering tube bracket nuts.
7. Disconnect the power steering tubes.
All vehicles
8. Remove the brake master cylinder nuts and remove the brake master cylinder.
9. To install, reverse the removal procedure.
- Bleed the brake system.
- Bleed the Hydro-Boost system.