Brake Pedal and Bracket
Brake Pedal and BracketRemoval and Installation
Vehicles equipped with adjustable pedal
1. Remove the brake pedal motor.
Vehicles with fixed pedal
2. Remove the stoplight switch retaining pin.
3. Slide the stoplight switch and booster push rod from the brake pedal pin.
All vehicles
4. Remove the brake pedal and bracket retaining nuts.
Vehicles equipped with 7.3L diesel engine
5. Remove the air cleaner assembly.
All vehicles
6. Position the brake booster assembly out of the way.
7. Remove the brake pedal and bracket.
8. CAUTION: The brake pedal and the accelerator pedal must be in the same position before installation. The pedals must be in the completely rearward (toward the driver) position.
To install, reverse the removal procedure.