Brake Pedal Motor

Brake Pedal Motor

Removal and Installation
1. Place the gearshift lever in first gear.





2. Disconnect the brake pedal motor electrical connector.





3. Disconnect the brake pedal motor-to-accelerator pedal cable from the accelerator pedal by pulling the cable retainer outward.





4. Disconnect the brake pedal motor-to-brake pedal cable from the brake pedal by pulling the cable retainer outward.





5. Disconnect the transmission shift cable from the steering column shift tube lever.





6. Remove the spotlight switch retaining pin.





7. Slide the stoplight switch and booster push rod from the brake pedal pin.





8. Remove the brake pedal motor bolts.

9. NOTE: Brake pedal motor-to-pedal cable must be routed around the main wiring harness to prevent cable binding.

NOTE: Hand-tighten the bolts.

To install, reverse the removal procedure.