Removal & Installation

Remove the parking brake control. See PARKING BRAKE CONTROL .
On vehicles with floor console, remove the 2 bolts and the floor console bracket. See Fig 2 .
On vehicles without floor console, remove the left front seat. See REMOVAL & INSTALLATION in appropriate POWER SEATS article.
Remove the left front door scuff plate. See Fig 3 .
Remove the left lower "A" pillar trim panel.
Remove the left front safety belt.
Pull back carpet to gain access to the console bracket.
Remove the 2 bolts and the floor console bracket.
On all vehicles, raise and support vehicle.
Disconnect the parking brake cable from the right side rear parking brake cable. See Fig 1 . Disconnect the front parking brake cable from the parking brake cable equalizer.
To install, reverse removal procedure.

Fig 1: Disconnecting Right Side Rear Parking Brake Cable

Courtesy of FORD MOTOR CO.

Fig 2: Identifying Floor Console Bracket

Courtesy of FORD MOTOR CO.

Fig 3: Removing Left Front Door Scuff Plate

Courtesy of FORD MOTOR CO.