LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Escape 3.0 1, FWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Overhaul >> Master Cylinder >> Disassembly

Master Cylinder: Disassembly

  1. Remove master cylinder. See MASTER CYLINDER & RESERVOIR  under REMOVAL & INSTALLATION.
  2. Clean outside of master cylinder.
  3. Remove the brake master cylinder reservoir.
  4. Remove the seals. See Fig 1 .
  5. Remove the snap ring. See Fig 2 .
  6. Remove the primary and secondary piston. See Fig 3 and Fig 4 .
  7. Use isopropyl alcohol to clean and inspect the brake master cylinder bore for damage.
Fig 1: Identifying Master Cylinder Reservoir "O" Rings
G00299585Courtesy of FORD MOTOR CO.
Fig 2: Identifying Master Cylinder Snap Ring
G00299586Courtesy of FORD MOTOR CO.
Fig 3: Removing Primary Piston
G00299587Courtesy of FORD MOTOR CO.
Fig 4: Removing/Installing Secondary Piston
G00299588Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals