Removal And Installation
WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Insert the drive end of the jack handle, with the spare tire carrier key attached, through the opening left of the license plate. Lower and remove the spare tire assembly.
- Remove the guide tube.
- Remove the 2 spare tire carrier bolts.
- To install, tighten to 20 Nm (15 lb-ft).
- Remove the spare tire carrier.
- Turn the spare tire carrier to release it from the tabs.
- Pull out the spare tire carrier lock.
- To install, reverse the removal procedure.
NOTE:
Vehicle may be equipped with a spare tire lock. If so, the key is located in the glove compartment.