LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Escape 2.0 B >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Overhaul >> Disc Brake Caliper >> Reassembly

Disc Brake Caliper: Reassembly

  1. Apply clean brake fluid to NEW piston seal, and install in caliper bore groove. Ensure the seal is not twisted and is firmly seated in the caliper bore. Apply clean brake fluid to caliper bore. Coat piston and outside beads of dust boot with clean brake fluid.
  2. Push piston through boot until boot is around bottom (closed end) of piston. See Fig 1 . Position piston and boot directly over caliper bore. Spread dust boot over piston as it is installed.
  3. With bead seated in groove, carefully press straight down on piston until it bottoms in caliper bore. Do not cock or jam piston in caliper bore. If necessary, use a "C" clamp and a block of wood to bottom piston in caliper bore.
Fig 1: Exploded View Of Single Piston Caliper
G95J28067Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals