LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 3168 (Engine Controls - Pinpoint Test HK: Variable Camshaft Timing (VCT) Through Pinpoint Test KA: Fuel Pump (FP) Relay - (Except Diesel & Hybrid)) >> PINPOINT TEST KA: Fuel Pump (FP) Relay >> Introduction

PINPOINT TEST KA: Fuel Pump (FP) Relay: Introduction

WARNING: This page does not describe the selected car, but rather 25 other vehicles, including the 2012 Lincoln Navigator L, 2012 Lincoln Navigator, 2012 Lincoln MKZ, 2012 Lincoln MKX, and 2012 Lincoln MKT. However, it is still accessible from the selected car via links, so may be relevant.

This pinpoint test is intended to diagnose the following:

Fuel Pump (FP) Relay Connector 

The VPWR and FP circuits may be reversed in the harness connector. Refer to the appropriate System Wiring Diagrams article for schematic and connector information.

Fig 1: Identifying Fuel Pump (FP) Relay Connector
G07883954Courtesy of FORD MOTOR CO.
Fig 2: Identifying Inertia Fuel Shutoff (IFS) Switch Connector
G07883955Courtesy of FORD MOTOR CO.

Powertrain Control Module (PCM) Connector

For PCM connector views or reference values, refer to REFERENCE VALUES article.

Vehicle Connector Pin Circuit
Transit Connect 190-PIN B32 FPM
B19 FP
All other vehicles 140 PIN B30 FPM
B62 FP