LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2872 (Engine Ignition System - 6.8L (3V) -- F450 & F550 Super Duty) >> Removal And Installation >> Ignition Coil-On-Plug >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford F550 Super Duty and 2012 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the 10 ignition coil-on-plug electrical connectors.
    2. NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.
  2. Remove the bolts and the 10 ignition coil-on-plugs.
    • To install, tighten to 6 Nm (53 lb-in).
    3. NOTE: Verify that the ignition coil-on-plug spring is correctly located inside the ignition coil-on-plug boot and that there is no damage to the tip of the boot.
  3. To install, reverse the removal procedure.
    • Apply a light coat of dielectric compound to the inside of the ignition coil-on-plug boots.
scientia non olet · About LEMON Manuals