LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2835 (Four Wheel Drive (4WD) Systems -- F250-F550 Super Duty) >> Removal And Installation >> Mode Indication Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Only vehicles with a mechanical shift transfer case are equipped with a Mode Indication Switch (MIS).
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the wiring harness connector.
  3. Remove the MIS switch.
    • To install, tighten to 31 Nm (23 lb-ft).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals