LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2832 (Steering Column Switches -- F250-F550 Super Duty) >> Removal And Installation >> Steering Column Control Module (SCCM) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. If a new SCCM is being installed, connect the scan tool and upload the module configuration information from the original SCCM. For additional information on configuration, refer to PMI in GENERAL PROCEDURES .
  2. Remove the steering wheel rotation sensor. For additional information, refer to ANTI-LOCK BRAKE SYSTEM (ABS) AND STABILITY CONTROL .
  3. Remove the steering column shrouds. For additional information, refer to STEERING COLUMN .
  4. Refer to exploded view(s) and any Warnings, Notices, Notes, Materials, Specifications and Special Tools. Items in the exploded views may not be listed in order of removal.
  5. To install, reverse the removal procedure.
    • If a new SCCM was installed, it must be configured (using vehicle as-built data or module configuration information retrieved earlier in this procedure). For additional information on configuration, refer to PMI in GENERAL PROCEDURES .
scientia non olet · About LEMON Manuals