LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2804 (Engine Mechanical - 6.2L (2V) - F250-F350 Super Duty) >> In-Vehicle Repair >> Oil Pump Screen and Pickup Tube >> Installation

Oil Pump Screen and Pickup Tube: Installation

WARNING: This page is about a different car, the 2012 Ford Pickup and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Make sure the O-ring is in place and not damaged. A missing or damaged O-ring can cause foam in the lubrication system, low oil pressure and severe engine damage.
    NOTE: Clean and inspect the mating surfaces and install a new O-ring. Lubricate the O-ring with clean engine oil prior to installation.
    Fig 1: Locating Oil Pump Screen And Pickup Tube Bolts
    G06518263Courtesy of FORD MOTOR CO.
  1. Position the oil pump screen and pickup tube and install the 2 front bolts.
    • Tighten to 10 Nm (89 lb-in).
  2. Install the oil pump screen and pickup tube support bracket nut.
    • Tighten to 24 Nm (18 lb-ft).
    Fig 2: Locating Oil Pump Screen And Pickup Tube Support Bracket Nut
    G06518262Courtesy of FORD MOTOR CO.
  3. Install the oil pan. For additional information, refer to Oil Pan .
scientia non olet · About LEMON Manuals