Throttle Body: Installation
WARNING: This page is about a different car, the 2011 Ford F550 Super Duty and 2011 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
- Using a new O-ring seal, install the TB
and tighten the 4 bolts in 2 stages.
- Stage 1: Tighten to 9 Nm (80 lb-in).
- Stage 2: Tighten an additional 90 degrees (1/4 turn).
- Connect the TP sensor electrical connector.
- Connect the ETC electrical connector.
- Install the ACL outlet tube. For additional information, refer to INTAKE AIR DISTRIBUTION SYSTEM & INTAKE AIR FILTERING SYSTEM .