Throttle Body - Spacer: Installation
WARNING: This page is about a different car, the 2011 Ford F550 Super Duty and 2011 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
- Install a new TB
spacer gasket and the TB
spacer and tighten the 4 lower bolts in 2 stages:
- Stage 1: Tighten to 9 Nm (80 lb-in).
- Stage 2: Tighten an additional 90 degrees.
- Install the 2 upper TB
spacer bolts in 2 stages:
- Stage 1: Tighten to 9 Nm (80 lb-in).
- Stage 2: Tighten an additional 90 degrees.
- Install the PCV heated element and the 2 screws.
- Connect the EVAP canister purge valve quick connect coupling to the TB spacer. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION - GASOLINE AND DIESEL .
- Connect the PCV tube quick connect coupling to the TB spacer. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION - GASOLINE AND DIESEL .
- Install the TB . For additional information, refer to THROTTLE BODY in this service information.