LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2659 (Fuel Charging And Controls - 6.8L (3V) -- F450 & F550 Super Duty) >> Removal And Installation >> Fuel Pump Control Module >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Ford F550 Super Duty and 2011 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles 

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the Fuel Pump Control Module (FPCM) electrical connector.

    Pickup and Chassis Cab with Midship Fuel Tank 

  3. NOTE: Do not overtighten the fasteners or damage to the module may occur.

    Remove the 2 nuts, stud plate and the FPCM  .

    • To install, tighten to 10 Nm (89 lb-in).

    Chassis Cab with Aft of Axle Fuel Tank 

  4. NOTE: Do not overtighten the fasteners or damage to the module may occur.

    Remove the 2 bolts and the FPCM  .

    • To install, tighten to 8 Nm (71 lb-in).

    All vehicles 

  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals