Removal and Installation

WARNING: This page is about a different car, the 2011 Ford Pickup, 2011 Ford F550 Super Duty, 2011 Ford F450 Super Duty, and 2011 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Left side shown in illustration , right side similar.

NOTE: Fender-moulding is one-time-use only.

Remove the 5 rear fender wheel moulding retainers.
Make sure all the old pressure sensitive tape is removed from the rear fender moulding mounting area.
NOTE: Before installing the new rear fender wheel moulding, clean the rear fender wheel moulding mounting area with an appropriate cleaner.
To install, reverse the removal procedure
NOTE: After installation apply 7-11 kg (15-25 lbf) of pressure with a roller along the entire perimeter, including the bottom underwrap normal to the surface.