LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2638 (Anti-Theft - Passive Anti-Theft System (Pats) -- F250-F550 Super Duty) >> General Procedures >> MyKey® Programming >> Program a MyKey™ >> Clear MyKey™ >> With Base Message Center

With Base Message Center

WARNING: This page is about a different car, the 2011 Ford Pickup, 2011 Ford F550 Super Duty, 2011 Ford F450 Super Duty, and 2011 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Insert an admin key into the ignition and turn the key to the RUN position.
    NOTE: This procedure is used to clear the MyKey™ feature on all of the keys that are programmed to the vehicle. All of the keys then operate as normal (admin) keys with no restrictions.
  2. Press SETUP until PRESS RESET TO CLEAR MYKEY is displayed.
  3. Press and release the RESET button until HOLD RESET TO CONFIRM CLEAR is displayed.
  4. Press and hold the RESET button until ALL MYKEYS CLEARED is displayed.
    • A MyKey™ can also be cleared during the same key cycle that it was programmed by following Steps 2, 3 and 4 of this procedure.
scientia non olet · About LEMON Manuals