LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2631 (Engine Cooling - Gasoline Engines -- F250-F550 Super Duty) >> Removal And Installation >> Coolant Pump >> Removal

Coolant Pump: Removal

WARNING: This page is about a different car, the 2011 Ford Pickup, 2011 Ford F550 Super Duty, 2011 Ford F450 Super Duty, and 2011 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the engine cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING  in this service information.
  2. Remove the cooling fan. For additional information, refer to COOLING FAN - 6.8L  for 6.8L engines or Cooling Fan Shroud - 6.2L  for 6.2L engines in this service information.
  3. Loosen the 4 coolant pump pulley bolts.
  4. Remove the accessory drive belt. For additional information, refer to ENGINE ACCESSORY DRIVE BELTS article.
  5. Remove the 4 bolts and the coolant pump pulley.
  6. Remove the 4 bolts and the coolant pump. Discard the O-ring seal.
  7. Inspect the sealing surfaces and clean with metal surface prep. Follow the directions on the packaging.
scientia non olet · About LEMON Manuals