LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2602 (Wheel Hubs & Bearings - Full Floating Axle - DANA -- F350-F550 Super Duty) >> Removal And Installation >> Axle Shaft >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Ford Pickup, 2011 Ford F550 Super Duty, 2011 Ford F450 Super Duty, and 2011 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the parking brake.
  2. Remove the 8 axle shaft bolts.
    • To install, tighten to 133 Nm (98 lb-ft).
    Fig 1: Locating Axle Shaft Bolt
    G06776965Courtesy of FORD MOTOR CO.
  3. Remove the axle shaft.
    Fig 2: Locating Axle Shaft
    G06776966Courtesy of FORD MOTOR CO.
  4. Inspect the following components:
    • The O-ring for damage. Install a new O-ring as necessary.
    • The axle shaft for cracked material around the holes or oversized holes. Install new components as necessary.
    Fig 3: Locating Axle Shaft O-Ring
    G06776863Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
    NOTE: Lubricate the O-ring with premium long-life grease.
scientia non olet · About LEMON Manuals