LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2599 (Front Suspension - Rear Wheel Drive (RWD) -- F250-F550 Super Duty) >> Removal And Installation >> Axle - F-250, F-350 >> Installation

Axle - F-250, F-350: Installation

WARNING: This page is about a different car, the 2011 Ford Pickup, 2011 Ford F550 Super Duty, 2011 Ford F450 Super Duty, and 2011 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the pivot bushing for wear or damage. Install a new bushing as necessary.
  2. Position the front axle into the pivot bracket, install the new pivot bolt and nut until snug.
    NOTE: Tighten the axle pivot nut with the suspension at curb height or damage to the bushing may occur.
  3. Install the radius arm. For additional information, refer to RADIUS ARM - F-250, F-350 .
  4. Install the wheel spindle. For additional information, refer to WHEEL SPINDLE - F-250, F-350 .
  5. With the vehicle at curb height, tighten the new axle pivot nut to 175 Nm (129 lb-ft).
  6. Check and, if necessary, align the front end. For additional information, refer to SUSPENSION SYSTEM - GENERAL INFORMATION .
scientia non olet · About LEMON Manuals