LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2592 (Rear Suspension -- F250-F550 Super Duty) >> Removal And Installation >> Wheel Studs - Dual Rear Wheel (DRW) >> Installation

Wheel Studs - Dual Rear Wheel (DRW): Installation

WARNING: This page is about a different car, the 2011 Ford Pickup, 2011 Ford F550 Super Duty, 2011 Ford F450 Super Duty, and 2011 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the new wheel stud aligning the serrations in the wheel extension made by the original wheel stud.
    Fig 1: Positioning Wheel Stud
    G06776321Courtesy of FORD MOTOR CO.
  2. NOTE: Make sure to use washers that have an ID that is larger than the OD of the wheel stud serrations. Use enough washers (approximately 4) to allow the wheel stud to fully seat against the hub flange.

    Place 4 washers over the outside end of the wheel stud and thread a standard wheel nut with the flat side against the washers. Tighten the wheel nut until the wheel stud seats against the back side of the wheel extension.

    Fig 2: Locating Wheel Nut And Wheel Stud Seats
    G06381917Courtesy of FORD MOTOR CO.
  3. Remove the wheel nut and washers.
scientia non olet · About LEMON Manuals