LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2587 (Fuel Tank & Fuel Lines -- F250-F550 Super Duty) >> Removal And Installation >> Fuel Tank Filler Pipe - Midship >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Ford Pickup, 2011 Ford F550 Super Duty, 2011 Ford F450 Super Duty, and 2011 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Remove the fuel filler cap slowly. The fuel system may be under pressure. If the fuel filler cap is venting vapor or if you hear a hissing sound, wait until it stops before completely removing the fuel filler cap. Otherwise, fuel may spray out. Failure to follow these instructions may result in serious personal injury.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY, BATTERY MOUNTING SYSTEM & BATTERY CABLES article.
  3. Drain the fuel tank until the fuel level is at or below half. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION - GASOLINE AND DIESEL article.
  4. Loosen the 2 hose clamps, disconnect the fuel tank filler pipe and fuel tank filler pipe vent tube.
  5. Remove the fuel tank filler cap.
  6. Remove the 3 fuel tank filler pipe upper retaining screws.
  7. Remove the fuel filler pipe assembly.
  8. To install, reverse the removal procedure.