Torque Specifications
WARNING: This page is about a different car, the 2011 Ford Pickup and 2011 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in | ||
|---|---|---|---|---|---|
| A/C compressor bolts | 25 | 18 | - | ||
| A/C delete idler and bracket assembly bolts | 25 | 18 | - | ||
| Accessory drive belt tensioner bolt | 25 | 18 | - | ||
| Accessory drive belt idler bolt | 25 | 18 | - | ||
| Axle carrier mounting bushing bolts | 115 | 85 | - | ||
| Camshaft bearing cap bolts(1) | - | - | - | ||
| Camshaft phaser and sprocket boltsa | - | - | - | ||
| Camshaft Position (CMP) sensor bolt | 10 | - | 89 | ||
| Connecting rod boltsa | - | - | - | ||
| Coolant pump boltsa | - | - | - | ||
| Coolant pump pulley bolts | 25 | 18 | - | ||
| Crankshaft rear seal retainer plate boltsa | - | - | - | ||
| Crankshaft damper pulley bolta | - | - | - | ||
| Crankshaft main bearing bolts (cross-mounted)a | - | - | - | ||
| Crankshaft main bearing bolts (vertical)a | - | - | - | ||
| Crankshaft Position (CKP) sensor bolt | 10 | - | 89 | ||
| Cylinder head boltsa | - | - | - | ||
| Cylinder Head Temperature (CHT) sensor | 10 | - | 89 | ||
| Engine front cover boltsa | - | - | - | ||
| Engine Oil Pressure (EOP) switcha | - | - | - | ||
| Engine support insulator-to-cylinder block boltsa | - | - | - | ||
| Engine support insulator through bolt | 350 | 258 | - | ||
| Exhaust manifold heat shield bolts | 12 | - | 106 | ||
| Exhaust manifold nutsa | - | - | - | ||
| Exhaust manifold studs | 25 | 18 | - | ||
| Exhaust Y-pipe flange nuts | 40 | 30 | - | ||
| Flexplate boltsa | - | - | - | ||
| Flexplate inspection cover bolts | 34 | 25 | - | ||
| Flywheel boltsa | - | - | - | ||
| Front frame crossmember bolts | 90 | 66 | - | ||
| Fuel rail boltsa | - | - | - | ||
| Generator support bracket boltsa | - | - | - | ||
| Ground cable-to-engine front cover nut | 25 | 18 | - | ||
| Hood bolts | 12 | - | 106 | ||
| Heater coolant inlet fitting bolt | 10 | - | 89 | ||
| Heater coolant return fitting bolt | 10 | - | 89 | ||
| Intake manifold-to-cylinder head boltsa | - | - | - | ||
| Knock Sensor (KS) bolts | 20 | - | 177 | ||
| LH Engine support insulator-to-crossmember nuts | 200 | 148 | - | ||
| Oil coolera | - | - | - | ||
| Oil filtera | - | - | - | ||
| Oil filter adapter bolts | 25 | 18 | - | ||
| Oil level indicator tube bolt | 10 | - | 89 | ||
| Oil pan boltsa | - | - | - | ||
| Oil pan drain plug | 23 | 17 | - | ||
| Oil pump boltsa | - | - | - | ||
| Oil pump screen and pickup tube bolts | 10 | - | 89 | ||
| Oil pump screen and pickup tube nut | 24 | 18 | - | ||
| Oil pump stud boltsa | - | - | - | ||
| Piston oil cooler valve bolta | - | - | - | ||
| Power steering fluid return tube bolt | 23 | 17 | - | ||
| Power Steering Pressure (PSP) hose support bracket nut | 10 | - | 89 | ||
| Power steering pump bolts | 25 | 18 | - | ||
| RH Engine support insulator-to-crossmember nuts | 115 | 85 | - | ||
| RH Engine support insulator studs | 80 | 59 | - | ||
| Radio ignition interference capacitor nut | 25 | 18 | - | ||
| Rocker arm shaft assembly boltsa | - | - | - | ||
| Spark plug | 12 | - | 106 | ||
| Starter wiring harness support bracket nut | 10 | - | 89 | ||
| Steering shaft bolt | 28 | 21 | - | ||
| Thermostat housing bolts | 10 | - | 89 | ||
| Timing chain guide boltsa | - | - | - | ||
| Timing chain hydraulic tensioner boltsa | - | - | - | ||
| Torque converter-to-flexplate nuts | 36 | 27 | - | ||
| Transmission fluid cooler tube support bracket nut | 10 | - | 89 | ||
| Transmission fluid cooler tube rear support bracket bolt | 48 | 35 | - | ||
| Transmission support insulator-to-crossmember nuts | 115 | 85 | - | ||
| Transmission support insulator studs | 75 | 55 | - | ||
| Transmission-to-engine bolts | 48 | 35 | - | ||
| Valve cover boltsa | - | - | - | ||
| Wiring harness ground cable-to-cylinder head bolt | 10 | - | 89 | ||
|
|||||