LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2580 (Engine Mechanical - 6.2L (2V) -- F250-F350 Super Duty) >> In-Vehicle Repair >> Valve Springs >> Installation

Valve Springs: Installation

WARNING: This page is about a different car, the 2011 Ford Pickup and 2011 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: If the components are to be reinstalled, they must be installed in the same positions. Failure to follow this instruction may result in engine damage.
  1. Using a valve spring compressor, install the valve spring, the valve spring retainer and the valve spring retainer keys.
  2. Relieve the air pressure from the cylinder.
  3. Install the lower spark plug. For additional information, refer to ENGINE IGNITION - 6.2L (2V) article.
  4. Install the rocker arm shaft assembly onto the cylinder head being serviced. For additional information, refer to ROCKER ARM  in this service information.
scientia non olet · About LEMON Manuals