LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2580 (Engine Mechanical - 6.2L (2V) -- F250-F350 Super Duty) >> In-Vehicle Repair >> Valve Cover - LH >> Removal

Valve Cover - LH: Removal

WARNING: This page is about a different car, the 2011 Ford Pickup and 2011 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION SYSTEM & INTAKE AIR FILTERING SYSTEM article.
  2. Disconnect the quick connect couplings and remove the crankcase ventilation tube. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION - GASOLINE AND DIESEL article.
  3. Disconnect the 4 LH ignition wires from the 4 LH ignition coils.
  4. Disconnect the 4 LH ignition wire retainers from the valve cover.
  5. Disconnect the LH Variable Camshaft Timing (VCT) solenoid electrical connector.
  6. Disconnect the 2 wiring harness retainers from the front and the 3 wiring harness retainers from the top of the LH valve cover.
    7. NOTE: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges which make leak paths. Use a plastic scraping tool to remove all traces of old sealant.
    NOTE: When removing the valve cover, make sure to avoid damaging the Variable Camshaft Timing (VCT) solenoid.
    NOTE: The fasteners are part of the valve cover and should not be removed.
  7. Loosen the 10 fasteners and remove the LH valve cover and gasket.
    • Clean the valve cover mating surface of the cylinder head with silicone gasket remover and metal surface prep. Follow the directions on the packaging.
    • Discard the valve cover gasket. Clean the valve cover gasket groove with soap and water or a suitable solvent.
scientia non olet · About LEMON Manuals