LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2580 (Engine Mechanical - 6.2L (2V) -- F250-F350 Super Duty) >> In-Vehicle Repair >> Oil Level Indicator and Tube >> Installation

Oil Level Indicator and Tube: Installation

WARNING: This page is about a different car, the 2011 Ford Pickup and 2011 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Lubricate the new oil level indicator tube O-ring seal with clean engine oil prior to installation.
  1. Using a new O-ring seal, install the oil level indicator tube and the bolt.
    • Tighten to 10 Nm (89 lb-in).
  2. Install the oil level indicator.
  3. Install the RH engine support insulator-to-cylinder block bracket. For additional information, refer to ENGINE SUPPORT INSULATORS  in this service information.
  4. Install the RH exhaust manifold. For additional information, refer to EXHAUST MANIFOLD - RH  in this service information.
scientia non olet · About LEMON Manuals