Turbocharger Actuator Cooler: Installation

WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Position the turbocharger actuator cooler and install the 3 bolts. Tighten the 3 bolts in the sequence shown in illustration in 2 stages.
- Stage 1: Finger-tighten the bolts.
- Stage 2: Tighten to 7 Nm (62 lb-in).
  
  Fig 1: Identifying Turbocharger Actuator Cooler Bolts In Tightening Sequence
  Courtesy of FORD MOTOR CO.
Tighten the 3 turbocharger actuator bolts.
- Tighten to 19 Nm (168 lb-in).
Connect the expansion tank-to-turbocharger actuator cooler hose to the actuator.
Connect the turbocharger actuator cooler-to-radiator hose to the cooler.
Fill and bleed the fuel and turbocharger cooling system. For additional information, refer to FUEL AND TURBOCHARGER COOLING SYSTEM DRAINING, FILLING AND BLEEDING .