LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2544 (Turbocharger Cooling System -- F250-F550 Super Duty) >> Removal And Installation >> Radiator >> Installation

Removal And Installation: Radiator: Installation

WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Do not tighten the fuel cooling system radiator bolt at this time. The fuel cooling system radiator must be removed and positioned horizontally to manually bleed the fuel cooling system. Only install the bolt tight enough to ease connection of the coolant hoses to the fuel cooling system radiator.
  1. Position the fuel cooling system radiator and install the bolt.
    • If bleeding the fuel cooling system manually, tighten the bolt finger-tight.
    • If using the RADIATOR REFILLER to fill the fuel cooling system, tighten the bolt to 12 Nm (106 lb-in).
  2. Fill and bleed the fuel and turbocharger cooling system. For additional information, refer to FUEL AND TURBOCHARGER COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
scientia non olet · About LEMON Manuals