Removal and Installation
WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Drain the fuel and turbocharger cooling system. For additional information, refer to FUEL AND TURBOCHARGER COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
- If necessary, remove and discard the tie straps.
- If necessary, position aside the coolant hose clip.
- Disconnect the coolant hose being serviced from the components on each end of the coolant hose and remove the coolant hose.
- To install, reverse the removal procedure.
- If necessary, install new tie straps.
- Fill and bleed the fuel and turbocharger cooling system. For additional information, refer to FUEL AND TURBOCHARGER COOLING SYSTEM DRAINING, FILLING AND BLEEDING .