Removal and Installation
WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Drain the fuel and turbocharger cooling system. For additional information, refer to FUEL AND TURBOCHARGER COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
- Disconnect the fuel cooler-to-coolant expansion tank hose from the coolant expansion tank.
- Disconnect the coolant expansion tank-to-turbocharger actuator cooler hose from the coolant expansion tank.
- Remove the 3 bolts and the coolant expansion tank.
- To install, tighten to 9 Nm (80 lb-in).
- To install, reverse the removal procedure.
- Fill and bleed the fuel and turbocharger cooling system. For additional information, refer to FUEL AND TURBOCHARGER COOLING SYSTEM DRAINING, FILLING AND BLEEDING .