Removal and Installation

WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

If equipped, remove the overhead console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
Remove the RH and LH sun visor screws and the sun visors.
- If equipped, disconnect the electrical connectors.
  
  Fig 1: Locating Sun Visor Screw
  Courtesy of FORD MOTOR CO.
Remove the RH and LH sun visor retaining clips.
- Remove the sun visor retaining screws.
  
  Fig 2: Locating Sun Visor Retaining Clips
  Courtesy of FORD MOTOR CO.
Remove the RH and LH A-pillar trim panels. For additional information, refer to A-PILLAR TRIM PANEL .
Lower the glove compartment.
1. Open the glove compartment.
2. Depress the glove compartment stop and fully lower the glove compartment.
  
  Fig 3: Identifying Glove Compartment And Glove Compartment Stop
  Courtesy of FORD MOTOR CO.
Through the glove compartment opening, disconnect the headliner electrical connector that is located at the RH instrument panel, toward the front of the vehicle.
Remove the RH and LH B-pillar trim panels. For additional information, refer to B-PILLAR TRIM PANEL - REGULAR CAB .
Remove the RH and LH rear garment hooks.

NOTE: Make sure not to crease the headliner when removing it from the vehicle.

With an assistant, remove the headliner.
To install, reverse the removal procedure.